HP OpenVMS Version 8.3 Upgrade and Installation Manual > Chapter 3 Installing the OpenVMS Operating System

Rebooting after AUTOGEN

  Table of Contents



After AUTOGEN finishes, the system automatically shuts down and displays messages similar to the following:

   The system will automatically reboot after the shutdown and the
installation will be complete.

SHUTDOWN -- Perform an Orderly System Shutdown
on node I64CSI

%SHUTDOWN-I-BOOTCHECK, performing reboot consistency check...
%SHUTDOWN-I-CHECKOK, basic reboot consistency check completed

The OpenVMS Alpha system should automatically reboot after the shutdown; the installation is finished. However, if the Alpha system does not reboot automatically, reboot the system manually. For example, if the system disk is on an RZ25 disk drive with a unit number of 1, enter the following command and press Enter:

   >>> BOOT DKA400

After shutdown of an OpenVMS I64 system, it reboots automatically only if you have set the system disk boot option accordingly; otherwise, you must boot the system manually, as described in “Booting the OpenVMS I64 System Disk”.

When the system reboots, it displays informational messages and accounting information indicating that your OpenVMS operating system has finished booting and is now ready for use. For example:

   %SET-I-INTSET, login interactive limit = 64, current interactive value = 0
SYSTEM job terminated at 15-JUL-2006 14:51:23.47
Accounting information:
Buffered I/O count: 2177 Peak working set size: 6848
Direct I/O count: 1358 Peak page file size: 179552
Page faults: 1805 Mounted volumes: 0
Charged CPU time: 0 00:00:13.37 Elapsed time: 0 00:01:06.20