The following sections show excerpts from
kern.log
files in
the
/var/adm/syslog.dated/date
directories:
Startup messages after running
clu_create
(Section E.1)
Startup messages after running
clu_add_member
(Section E.2)
These messages track normal cluster startup operations; therefore, in
addition to providing some level of assurance that cluster formation
and recovery operations are proceeding in an orderly fashion, they
also provide a starting point for troubleshooting cluster-related
problems.
E.1 Startup Messages After Running clu_create
Example E-1
shows a transcript of a portion
of the startup messages displayed during a reboot of the first cluster member
system after running
clu_create.
This information is also written to
/var/adm/syslog.dated/date/kern.log.
Example E-1: Startup Messages After Running clu_create
Alpha boot: available memory from 0x1710000 to 0x7f58000 Compaq Tru64 UNIX T5.1B-4 (Rev. 2350); Tue Apr 23 16:10:43 EDT 2002 physical memory = 128.00 megabytes. available memory = 104.27 megabytes. using 413 buffers containing 3.22 megabytes of memory Firmware revision: 5.8-10 PALcode: UNIX version 1.79-63 AlphaServer DS20 500 MHz pci1 (primary bus:1) at nexus pci2 (primary bus:1 subordinate bus:2) at pci1 slot 7 itpsa0 at pci2 slot 0 IntraServer ROM Version V2.0 (c)1998 scsi0 at itpsa0 slot 0 rad 0 itpsa1 at pci2 slot 1 IntraServer ROM Version V2.0 (c)1998 scsi1 at itpsa1 slot 0 rad 0 tu0: DECchip 21140: Revision: 2.2 tu0: auto negotiation capable device tu0 at pci2 slot 2 tu0: DEC TULIP (10/100) Ethernet Interface, hardware address: 00-06-2B-00-FC-99 tu0: auto negotiation off: selecting 10BaseT (UTP) port: half duplex pci0 (primary bus:0) at nexus isa0 at pci0 gpc0 at isa0 gpc1 not probed ace0 at isa0 ace1 at isa0 lp0 at isa0 fdi0 at isa0 fd0 at fdi0 unit 0 ata0 at pci0 slot 105 (slot 5, function 1) ata0: CYPRESS 82C693 scsi2 at ata0 slot 0 rad 0 ata1 at pci0 slot 205 (slot 5, function 2) ata1: CYPRESS 82C693 scsi3 at ata1 slot 0 rad 0 usb0 at pci0 slot 305 (slot 5, function 3) comet0: Card type 'Elsa GLoria' with 8MB framebuffer memory. comet0 at pci0 slot 7 emx0 at pci0 slot 8 KGPSA-CA : Driver Rev 2.03 : F/W Rev 3.03X2(1.11) : wwn 1000-0000-c924-4b7b emx0: Using console topology setting of : Fabric scsi4 at emx0 slot 0 rad 0 mchan0: Module revision = 34 mchan0: jumpered as HUB configuration mchan0 at pci0 slot 9 Created FRU table binary error log packet kernel console: comet0 i2c: Server Management Hardware Present dli: configured NetRAIN configured. Random number generator configured. ATM Subsystem configured with 1 restart threads ATMUNI: configured ATMSIG: 3.x (module=uni3x) configured ILMI: 3.x (module=ilmi) configured ATM IP: configured ATM LANE: configured. ATM IFMP: configured TruCluster Server T5.1B-4 (Rev. 639); 04/11/02 04:20 Warning: subsystem xpc is neither new nor old format, not configured. clubase: configured Configuring RDG to use Memory Channel ics_hl: Configuring memory channel as transport. icsnet: configured drd configured 0 kch: configured dlm: configured Starting CFS daemons Registering CFS Services Initializing CFSREC ICS Service Registering CFSMSFS remote syscall interface Registering CMS Services TNC kproc_creator_daemon: Initialized and Ready rm slave: mchan0, hubslot = 4, phys_rail 0 (size 512 MB) rm slave: log_rail 0 (size 512 MB), phys_rail 0 (mchan0) ics_mct: icsinfo set for node 1 ics_mct: Declaring this node up 1 CNX MGR: insufficient votes to form cluster: have 1 need 2 ics_mct: icsinfo set for node 2 CNX MGR: Cluster deli incarnation 0x9e2b4 has been formed CNX MGR: Founding node id is 2 csid is 0x10001 CNX MGR: membership configuration index: 1 (1 additions, 0 removals) CNX MGR: quorum (re)gained, (re)starting cluster operations. Joining versw kch set. CNX MGR: Node swiss 1 incarn 0xe6e30 csid 0x10002 has been added to the cluster ics_mct: Declaring this node up 2 CNX MGR: Node rye 2 incarn 0xcac0e csid 0x10001 has been added to the cluster dlm: resuming lock activity kch: resuming activity scsi1: SCSI Bus was reset cam_logger: SCSI event packet cam_logger: bus 1 target 255 lun 255 itpsa SCSI HBA SCSI Bus was reset scsi1: SCSI Bus was reset cam_logger: SCSI event packet cam_logger: bus 1 target 255 lun 255 itpsa SCSI HBA SCSI Bus was reset scsi1: SCSI Bus was reset cam_logger: SCSI event packet cam_logger: bus 1 target 255 lun 255 itpsa SCSI HBA SCSI Bus was reset scsi1: SCSI Bus was reset cam_logger: SCSI event packet cam_logger: bus 1 target 255 lun 255 itpsa SCSI HBA SCSI Bus was reset clsm: checking for peer configurations clsm: initialized Waiting for cluster mount to complete clsm: sent CNX partition data vm_swap_init: swap is set to eager allocation mode CMS: Joining deferred filesystem sets CNX QDISK: Successfully claimed quorum disk, adding 1 vote. cluster alias subsystem enabled Environmental Monitoring Subsystem Configured.
See the
Cluster Administration
manual for descriptions of
information and error
messages generated by TruCluster Server.
E.2 Startup Messages After Running clu_add_member
Example E-2
shows a transcript of a portion of
the startup messages displayed during the first boot of the second cluster
member system after running
clu_add_member.
This
information is also written to
/var/adm/syslog.dated/date/kern.log.
Example E-2: Startup Messages After Running clu_add_member
Alpha boot: available memory from 0x1ab8000 to 0xff58000 Compaq Tru64 UNIX T5.1B-4 (Rev. 2350); Tue Apr 23 16:10:07 EDT 2002 physical memory = 256.00 megabytes. available memory = 228.61 megabytes. using 905 buffers containing 7.07 megabytes of memory Firmware revision: 5.8-10 PALcode: UNIX version 1.79-63 AlphaServer DS20 500 MHz pci1 (primary bus:1) at nexus pci2 (primary bus:1 subordinate bus:2) at pci1 slot 7 itpsa0 at pci2 slot 0 IntraServer ROM Version V2.0 (c)1998 scsi0 at itpsa0 slot 0 rad 0 itpsa1 at pci2 slot 1 IntraServer ROM Version V2.0 (c)1998 scsi1 at itpsa1 slot 0 rad 0 tu0: DECchip 21140: Revision: 2.2 tu0: auto negotiation capable device tu0 at pci2 slot 2 tu0: DEC TULIP (10/100) Ethernet Interface, hardware address: 00-06-2B-01-1F-5A tu0: auto negotiation off: selecting 10BaseT (UTP) port: half duplex mchan0: Module revision = 34 mchan0: jumpered as HUB configuration mchan0 at pci1 slot 8 pci0 (primary bus:0) at nexus isa0 at pci0 gpc0 at isa0 gpc1 not probed ace0 at isa0 ace1 at isa0 lp0 at isa0 fdi0 at isa0 fd0 at fdi0 unit 0 ata0 at pci0 slot 105 (slot 5, function 1) ata0: CYPRESS 82C693 scsi2 at ata0 slot 0 rad 0 ata1 at pci0 slot 205 (slot 5, function 2) ata1: CYPRESS 82C693 scsi3 at ata1 slot 0 rad 0 usb0 at pci0 slot 305 (slot 5, function 3) comet0: Card type 'Elsa GLoria' with 8MB framebuffer memory. comet0 at pci0 slot 7 emx0 at pci0 slot 9 KGPSA-CA : Driver Rev 2.03 : F/W Rev 3.02A1(1.11) : wwn 1000-0000-c922-4aac emx0: Using console topology setting of : Fabric scsi4 at emx0 slot 0 rad 0 Created FRU table binary error log packet kernel console: comet0 i2c: Server Management Hardware Present dli: configured NetRAIN configured. Random number generator configured. ATM Subsystem configured with 1 restart threads ATMUNI: configured ATMSIG: 3.x (module=uni3x) configured ILMI: 3.x (module=ilmi) configured ATM IP: configured ATM LANE: configured. ATM IFMP: configured TruCluster Server T5.1B-4 (Rev. 639); 04/11/02 04:20 Warning: subsystem xpc is neither new nor old format, not configured. clubase: configured Configuring RDG to use Memory Channel ics_hl: Configuring memory channel as transport. icsnet: configured drd configured 0 kch: configured dlm: configured Starting CFS daemons Registering CFS Services Initializing CFSREC ICS Service Registering CFSMSFS remote syscall interface Registering CMS Services TNC kproc_creator_daemon: Initialized and Ready rm primary: mchan0, hubslot = 2, phys_rail 0 (size 512 MB) rm primary: log_rail 0 (size 512 MB), phys_rail 0 (mchan0) ics_mct: icsinfo set for node 2 ics_mct: Declaring this node up 2 ics_mct: icsinfo set for node 1 CNX MGR: Cluster deli incarnation 0x9e2b4 has been formed CNX MGR: Founding node id is 2 csid is 0x10001 CNX MGR: membership configuration index: 1 (1 additions, 0 removals) CNX MGR: quorum (re)gained, (re)starting cluster operations. CNX MGR: Node rye 2 incarn 0xcac0e csid 0x10001 has been added to the cluster Joining versw kch set. ics_mct: Declaring this node up 1 CNX MGR: Node swiss 1 incarn 0xe6e30 csid 0x10002 has been added to the cluster dlm: resuming lock activity kch: resuming activity clsm: incoming CNX data: '…a' clsm: checking for peer configurations clsm: initialized Waiting for cluster mount to complete vm_swap_init: swap is set to eager allocation mode CMS: Joining deferred filesystem sets CNX QDISK: Successfully claimed quorum disk, adding 1 vote. cluster alias subsystem enabled Environmental Monitoring Subsystem Configured.