HP Instant Capacity User's Guide for versions 8.x > Chapter 2 Getting Started

Instant Capacity Software Validation

  Table of Contents

  Index

On HP-UX Systems

The Instant Capacity software (HP-UX product B9073BA) is installed by HP manufacturing on instantly ignited HP-UX systems. The Instant Capacity software can also be installed by an HP service representative on existing (supported) HP-UX enterprise servers as an add-on.

NOTE: The Instant Capacity software is automatically installed when the HP-UX 11i v2 or 11i v1 Operating Environment (OE) is installed.

To verify the Instant Capacity software is installed on your system, execute the following HP-UX command:

/usr/sbin/swlist B9073BA

You should see output similar to:

B9073BA   B.11.23.08.00   HP-UX iCOD Instant Capacity (iCAP)

To ensure the Instant Capacity software installation has not been corrupted, execute the following HP-UX command:

/usr/sbin/swverify B9073BA

You should see Verification succeeded. in the output of the swverify command.

On OpenVMS Systems

On OpenVMS systems, the Instant Capacity software is automatically installed on partitionable systems when the OpenVMS I64 V8.3 or later operating system in installed. You should not need to install iCAP software separately on OpenVMS systems. On-site iCAP installation by an HP service representative after the initial installation of OpenVMS 8.3 is not an option for OpenVMS systems.

On OpenVMS systems, run the following commands to verify the Instant Capacity software is installed and configured:

$ @sys$manager:ICAP$CLI_UTILS.COM CONFIG_CHECK
$ show log ICAP$CONFIGURED
"ICAP$CONFIGURED" = "TRUE" (LNM$JOB_nnnnnnnn)